FECHTER DRIVE

The section closure in the Lech Valley is specified for motorcycles with a registered standing noise of more than 95 dB (A). You can find your standing nois...

The performance of SHARK, HURRIC and FALCON exhaust systems is in the range of the original exhaust system for your vehicle (+/- 2 HP). For this reason, we ...

So that we can answer your request, we need the item number of the exhaust system you have. Without the item number, we unfortunately cannot make a statemen...

Case 1) Your exhaust system is "subjectively" too loud Extra quiet dB-killers are available for most exhaust systems. If you would like to reques...

Normal and typical engine bubbling after installing an accessory exhaust system In a large number of cases, the typical engine bubbling that becomes more n...

Please check whether the entire exhaust system has been fitted tightly and no exhaust gases are blowing off at one point or whether the exhaust system is dr...

Step 1): Please check the dB-killer screws for correct seating and tighten them. Step 2): If necessary, secure them with heat-resistant Loctite. If the dB-...

In our fitting instructions, we expressly point out that the screws of the dB-killer must be retightened before and after the first journey and after 1,000 ...

If the plug connection between the individual manifold parts, the intermediate pipe to the manifold or the rear silencer to the intermediate pipe is not per...